Berber Scarf - A Free Tapestry Crochet Pattern

Berber Scarf Tapestry Crochet Pattern

Worked in rows of UK treble crochets, this modern Berber-inspired scarf uses tapestry crochet to create a stunning monochrome design.








I'm so excited to be sharing this free pattern with you. This scarf was inspired by all the beautiful Berber rugs around at the moment, and made possible by some beautiful Phildar Nuage yarn from Hobbycraft. I really recommend this yarn, it's like working with fluffy clouds! Otherwise, any chunky yarn with a 7mm hook should work up nicely for you!

Materials

3 x Balls of Phildar ‘Phil Nuage’ in Flocon (50g, 72% Merino Wool, 28% Nylon) (Yarn 1)

1 x Balls of Phildar ‘Phil Nuage’ in Suie (50g, 72% Merino Wool, 28% Nylon) (Yarn 2)

7mm crochet hook

Scissors

Yarn needle



Gauge

10cm (4in) square = 12 treble crochet stiches x 7 rows

Gauge is not essential for this project. As a guide, the above worked up to a scarf with the finished measurements of approx. 25cm (9.5in) x 195cm (76.5in)


Abbreviations

ch           chain

sts          stitches

dc           double crochet (US single)

tr             treble crochet (US double)


Stitches

Double crochet (US single)

Insert hook into required stitch, yarn over and pull up a loop (two loops on hook), yarn over and pull through both loops.


Treble crochet (US double)

Yarn over (two loops on hook) and insert into required stitch, yarn over and pull up a loop (three loops on hook), yarn over and pull through two loops (two loops on hook), yarn over and pull through remaining two loops.


Bobble stitch

To make a bobble stitch: *Yarn over and insert into required stitch, yarn over and pull up a loop, yarn over and pull through two loops – do not finish stitch. Instead, Repeat from * four more times (working into the same stitch on the row below each time) then yarn over one last time and pull through all the loops on the hook.



Pattern Notes

Starting chains do not count as stitches throughout.

There are six bobble stitches in the pattern, three on Row 33 and three on Row 93, they are marked by black rectangles on the grid.


Tapestry Crochet Technique

Tapestry crochet allows you to use two (or more) colours on the same row of a pattern. You will need to ‘carry’ your second yarn inside the stitches of your first yarn.

·         Begin by crocheting the foundation chain in Yarn 1 (Y1). As you start Row 1, hold your second yarn (Y2) alongside the foundation chain. As you work the trebles of Row 1 in Y1, work over the top of Y2.

·         When you get to the end of Row 1, you will need to turn and Ch2. Make sure you bring Y2 round to the back of the work too, and work your Row 2 trebles over the top of it in the same way. You will be able to see Y2 at the end of each row, but don’t worry about this as we will crochet over it later.

·         To change colour from Y1 to Y2, crochet the last Y1 treble before the colour change to the last stage of the stitch (when you have two loops on your hook) then instead of yarning over and pulling through the loops with Y1, drop this colour and yarn over and pull through with Y2. You will now have Y2 ready to make the next stitch in that colour. Make sure that you work over the top of Y1 when making your stitch in Y2, in the same way you did in Row 1.

·         Continue crocheting and changing colour based on the graph. The key is to always change colours at the last stage of the stitch before.

·         Keep your tension as even as possible, and ensure that the yarn you are carrying is not too tight that it is puckering the fabric, or too loose that it is looping out between stitches.

·         Where the colour changes from the last stitch of one row to the first stitch of the next row (for example Rows 17-18), you will need to change colour at the last part of the last stitch of the row, then chain in your new colour, ready to start the next row in your new colour.







Reading the Graph

Each rectangle on the grid represents a stitch. Start in the bottom right hand corner in the yellow square, next to the number 1, and work from right to left on the first row, then left to right on the second row, and so on until the end of the pattern.





Scarf Pattern Starts

Foundation  

Using Y1, ch31 loosely


Row 1

Starting in the bottom right-hand corner of the graph, next to the number 1, bring in Y2 and tr in the third ch from the hook, and in each chain along until the end of the row – make sure you are working your Y1 tr over the top of Y2. Turn and Ch2. (29 sts)


Rows 2-125

Continue in tr using the tapestry crochet technique, and following the chart. At the end of each row you will need to turn and Ch2 (does not count as a stitch throughout).

The three black rectangles on Rows 33 and 93 are bobble stitches – see Pattern Notes above.


Row 126

At the end of Row 125, turn your work once more, ch1, and work a row of dc in Y1. Turn. (29 sts)

Cut Y2, leaving a long tail to sew in later.


Row 127

Ch1 and dc in the first stitch. *Ch1, skip a stitch, dc. Repeat from * until the end of the row. Do not turn.


Row 128 (long edge)

To even up your edges and to hide the carried yarn, I recommend working a row of dc along the side of the scarf. Without breaking your yarn or turning, rotate your work 90 degrees clockwise, and evenly work dc along the long edge of the scarf. Work one dc into the side of each dc row, and two dc into the side of each tr row.


Row 129

Repeat Row 127 along the other short edge of the scarf.


Row 130 (long edge)

Repeat Row 128 along the other long edge of the scarf. Cut and fasten off Y1.

The main body of your scarf is now complete! Sew in any ends using your yarn needle.



Tassels

If you would like to add tassels to your scarf, cut the following:

Y1: 28 x 20cm (8in) lengths

Y2: 56 x 20cm (8in) lengths

Each tassel will use two lengths of Y2 and one of Y1 held together. Along the short edges of the scarf, locate the chain spaces you made in Rows 127 and 129.

*Insert your crochet hook into one of the chain spaces from front the back, and loop your 3 tassel lengths over the crochet hook. Pull up a loop with the tassel yarn, and yarn over with the rest of the tassel. Now pull through the loop on the hook to secure your tassel. Repeat from * 13 times, and then again at the other end of the scarf.






If you feel it needs it, trim your tassels. Your scarf is now complete!


I hope you enjoyed this @lottieandalbert pattern. Please let me know if you have any questions via Instagram or www.lottieandalbert.blogspot.com.


You are free to make items to sell from this pattern but please credit Lindsey Newns @lottieandalbert as the designer.


When you’ve made the scarf we would love to see it! Use the hastags #lottieandalbert and #shareyourknitcraft, or tag us as @lottieandalbert and @knitcrafthq


This pattern has also been published on the Hobbycraft KnitcraftHQ blog, you can see the post here: How to Crochet a Tapestry Scarf




Back to blog

Leave a comment

Please note, comments need to be approved before they are published.